computer error
英 [kəmˈpjuːtə(r) ˈerə(r)]
美 [kəmˈpjuːtər ˈerər]
网络 计算机错误
英英释义
noun
- (computer science) the occurrence of an incorrect result produced by a computer
双语例句
- Conservation of geometric information is very important for Computer Aided Geometric Design ( CAGD), but only approximate results can be obtained in many cases for the approximation property of some algorithms and the existence of computer float error.
在计算机辅助几何设计中，几何信息的保存至关重要，而由于有些算法的近似性以及计算机浮点误差的存在，很多时候我们只能得到近似的结果。 - Performance Estimation and Computer Simulation of Error Control System in the Digital Mobile Communication Channel
移动数字信道差错控制系统性能估计与计算机模拟 - Computer Sampling Error Signal Control Output Voltage to Stabilize Frequency of the Ti ∶ sapphire Laser
计算机采样-输出实现钛宝石激光器稳频 - The last time this test was run on this computer, an error occured that caused you to terminate this program prematurely, or even reboot your computer.
本测试上次在本机上运行时，发生了错误，致使您过早结束本程序，甚至重新启动计算机。 - Applying computer error revision technique, the instrument can obtain higher measure accuracy.
使用计算机误差修正技术，又进一步提高了仪器的测角精度。 - Stepping motor, with it's convenience of connecting with computer, no error accumulation of output angle displacement, high precision in open loop, is becoming the important execute component.
由于其系统与计算机接口特别方便，输出角位移误差不会长期积累，开环运行有较高的精度，因而成为数控系统中的重要执行部件。 - Most computer programs use error messages as a way to mask programmer laziness.
大多数计算机程序采用错误消息作为掩盖程序员偷懒的方式。 - Predict High-speed Computer System Bit Error Rate Through Timing Jitter Model and Decomposition
通过抖动建模和分解计算高速计算机系统的误码率 - The computer simulation error resulted in impact of single particle and friction between particles is adjusted by introduction of an adjusting parameter.
考虑单个颗粒的速度引起的冲击作用以及颗粒间的摩擦力，引入调整参数来调整模拟误差。 - While the changing gear is selected by continued-fraction approach method and calculated by the aid of computer, the error in transmission ratio and tooth curve could be obviously reduced, the machining accuracy of gears can be enhanced and the time for selecting changing gear shortened.
采用连分数逼近的方法，借助于计算机辅助计算，大大降低了传动比误差及齿向误差，提高了齿轮加工精度，并可缩短挂轮选配时间。